Does anyone have a tried and tested technique for surface mounting DIP/DIL packaged IC's?
I was gonna bend the pins out or under and give it a try. I might even bend then over and mount the chip upside down for one particular circuit where the pinout would be much better 'mirror image'. I know it sounds daft, but I have my reasons.
Anyone had any experience of this madness?
Thanks in advance.
-Dalmation.
I was gonna bend the pins out or under and give it a try. I might even bend then over and mount the chip upside down for one particular circuit where the pinout would be much better 'mirror image'. I know it sounds daft, but I have my reasons.
Anyone had any experience of this madness?
Thanks in advance.
-Dalmation.