You must be correct. Both work the same even though the marks differ.kchriste said:I think it is just part of the injection molding process; it is the point where the plastic is injected into the mold for the casing.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
You must be correct. Both work the same even though the marks differ.kchriste said:I think it is just part of the injection molding process; it is the point where the plastic is injected into the mold for the casing.
blueroomelectronics said:I ordered from mouser once, had to pay $35 in duties and broker fees. Digikey no problem. Might not apply to US orders.
blueroomelectronics said:The 2N7000 and BS170 will both work, just depends on what part of the world you're in one will be more available than the other.
Preprogrammed 18F2550 comes with the kit, the firmware will update itself if it's older when you use MPLAB or PICKit2 software. You can even downgrade to 1.x if need be so you can recalibrate PIC12F chips (feature was removed in 2.x PICkit2 software)
DIY builders that have to supply their own 18F2550 will have to have access to a PIC programmer, sort of chicken before the egg problem.
Here's a useful tip for the MOSFETs (as they can be tricky to figure out DS)
* Use a multimeter to find the internal diode across D & S the Gate will be in the center.
Hahahahaha!!! That fatty inductor is hilarious! You couldn't find a bigger one?Krumlink said:I finally got my junebug working!!! (big thanks to 3v0, Bill for the board, looks awesome)
Heres a pic:
It is pretty "special", as in ride the short bus special. Reistors and caps too big, crystal too big, no DIP Switch but shorting blocks, Massive Toroid, Messed up
Krumlink said:Hey bill how do I get the demo to work? Do i follow the directions on the Hello world poster but instead put in its code?
That sounds normal. LED 3 will come on when the 18F1320 is blank. The green & yellow are normal and the red may flash. Run the PICkit2 standalone software availabe in the PICkit 2 section of Microchips site.thekyguy11 said:Hey guys...
Just finished assembling my Junebug today, and I don't think its working quite right. I followed the directions to a T, and everything is identical to the picture. When I hook up to the USB cable, the green and yellow leds come on and the 3rd larger led comes on and goes off. I don't know where to start?