StopGo
New Member
I tried again this time with some Epson 720dpi inkjet paper. This is not glossy but it does have a very smooth finish.
This time there was less of a problem, after ironing small air bubbles appeared in between the paper and copper. The bubbles were where there were no tracks. Once wetted, the bubbles seemed to expand. I was worried the trapped bubbles would lift the toner tracks. This paper seemed to peel off rather than rub off. My first couple of transfers did have missing tracks, due in part to experimenting with cooler iron temperatures.
My last attemp has been the best so far.. shame about my lack of drilling skills
**broken link removed**
This time there was less of a problem, after ironing small air bubbles appeared in between the paper and copper. The bubbles were where there were no tracks. Once wetted, the bubbles seemed to expand. I was worried the trapped bubbles would lift the toner tracks. This paper seemed to peel off rather than rub off. My first couple of transfers did have missing tracks, due in part to experimenting with cooler iron temperatures.
My last attemp has been the best so far.. shame about my lack of drilling skills
**broken link removed**