Torben
Well-Known Member
I'm checking it out, it looks a little confusing though.. when you auto-route does it actually know how to connect the power and ground to ICs 'cause in the schematic phase there are no power connection options.
I just sampled with 2 tl074's, when I auto-routed, it automatically connected both IC's grounds and VCCs together but did not connect them to the power supply.
In the schematic, you need to click the "Invoke" button, then click the IC symbol in question. You will then get a popup asking you to specify the gates you wish to add. Select "Power". This should give you a small symbol representing the Vcc and GND for the part which you can place as you like. Don't worry that it is not visibly connected to the part on the schematic; Eagle knows what is going on and it'll be connected properly in the board editor.
Make sense?
Torben