Hey,
I just did a basic dual stage temp switch circuit using the LM358N that I have been playing around with, I am yet to test this circuit but thought I would run it past you guru's and get your opinion on if it will work or if I need to adjust anything?
Basically it uses the same 10k thermistor on both non-inverting inputs A and B and uses two trim pots to set A and B's on point allowing the circuit to switch say two fans at different temps or something like that.
Let me know your thoughts.
Cheers
I just did a basic dual stage temp switch circuit using the LM358N that I have been playing around with, I am yet to test this circuit but thought I would run it past you guru's and get your opinion on if it will work or if I need to adjust anything?
Basically it uses the same 10k thermistor on both non-inverting inputs A and B and uses two trim pots to set A and B's on point allowing the circuit to switch say two fans at different temps or something like that.
Let me know your thoughts.
Cheers