Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

Value to simulate igbt and diode in ltspice from datasheet

Status
Not open for further replies.
I have igbt and diode data sheet used for inverter and rectifier circuit design.

i need simulate inverter in ltspice using the voltage controlled switch component.

How obtain to these values from the igbt/diode data sheet

datasheet is attached here
NameDescriptionUnits
RonResistance in forward conductionW
RoffResistance when offW
VfwdForward threshold voltage to enter conductionV
VrevReverse breakdown voltageV
RrevBreakdown impedanceW
IlimitForward current limitA
RevilimitReverse current limitA
EpsilonWidth of quadratic regionV
RevepsilonWidth of reverse quad. regionV





Is
saturation currentA
RsOhmic resistanceW
NEmission coefficient-
TtTransit-timesec
CjoZero-bias junction cap.F
VjJunction potentialV
MGrading coefficient-
EgActivation energyeV
XtiSat.-current temp. exp-
KfFlicker noise coeff.-
AfFlicker noise exponent1
FcCoeff. for forward-bias depletion capacitance formula-
BVReverse breakdown voltageV
IbvCurrent at breakdown voltageA
TnomParameter measurement temp.ºC
IsrRecombination current parameterA
NrIsr emission coeff.-
IkfHigh-injection knee currentA
TikfLinear Ikf temp coeff./ºC
Trs1linear Rs temp coeff./ºC
Trs2Quadratic Rs temp coeff./ºC/ºC






could anyone please help it?
 

Attachments

  • SEMIKRON_DataSheet_SKD_51_14_07223311.pdf
    235.5 KB · Views: 297
  • SEMIKRON_DataSheet_SKM50GB12T4_22892000.pdf
    464.3 KB · Views: 256
I used to work on pwm 3 phase inverters up to 13,000 hp, and used to mess around with multisim making inverters for fun in different configurations and components just see if i could make them to simulate and had pretty good luck usually.
Try multisim and use a fet for the base and drive a darlington.
The student version is plenty good enough for most projects rather than the expensive version.
I just checked and multisim does have an igbt in it, and you can edit parameters.
image7858064133284127528.jpeg
 
Last edited:
Status
Not open for further replies.

Latest threads

New Articles From Microcontroller Tips

Back
Top