Makaram
Member
Hey, Creating a motor switching H bridge that would only be used for say .5s bursts with a minimum of .5s between burst. The bursts would only be occasional as it will be used for a locking and unlocking application.
Say I want to allow for a current of up to 30A @ 12v, what kind of trace widths would I require?
I know there are plenty of calculators out there but I simply will not be using this continuously so I think a 1000mil trace is hardly necessary!
Thanks for any input you can provide
Matt
Say I want to allow for a current of up to 30A @ 12v, what kind of trace widths would I require?
I know there are plenty of calculators out there but I simply will not be using this continuously so I think a 1000mil trace is hardly necessary!
Thanks for any input you can provide
Matt