I have had to fix many pairs of headphones before but almost always encounter the same problem with the type of cable used:
It is so difficult to tin them and heating them too much always results in the thin plastic outer layer (jacket) melting.
It feels like the wire has plastic or other fibrous material woven with it to increase it's tensile strength and keep it kink free.
Anyone have tips on the best way to solder this type of wire?
It is so difficult to tin them and heating them too much always results in the thin plastic outer layer (jacket) melting.
It feels like the wire has plastic or other fibrous material woven with it to increase it's tensile strength and keep it kink free.
Anyone have tips on the best way to solder this type of wire?