Bristolian
New Member
Hello
I am a new member to this forum and i am also fairly new to electronics.
I do know a bit and am capable of reading basic schematics and reading resistor colour codes etc. I done a basic electronics course where i built a simple amp and a very simple theremin... But the lecturer helped with designing the PCB's
I want to build a reggae sound box / dub siren. I have found a schematic which is not over complex. I have been advised to build it on breadboard first to make sure it works and then to use a PCB.
I am having trouble with translating the schematic to breadboard and dont have a clue where to start with the PCB. I was wondering if there is anyone out there who might be able to help me?
Was also wondering, is "Express PCB" available for Mac?
Thanks
John
I am a new member to this forum and i am also fairly new to electronics.
I do know a bit and am capable of reading basic schematics and reading resistor colour codes etc. I done a basic electronics course where i built a simple amp and a very simple theremin... But the lecturer helped with designing the PCB's
I want to build a reggae sound box / dub siren. I have found a schematic which is not over complex. I have been advised to build it on breadboard first to make sure it works and then to use a PCB.
I am having trouble with translating the schematic to breadboard and dont have a clue where to start with the PCB. I was wondering if there is anyone out there who might be able to help me?
Was also wondering, is "Express PCB" available for Mac?
Thanks
John