Pspice simulation of my 3 phase inverter

Status
Not open for further replies.
M

maclea98

New Member
Trying to preform AC sweep on my pspice 3 phase inverter but simulation doesnt apear there are no errors could someone please help . I aslo need to keep transfering my traingular wave creator from previous try doesnt save correctly .
thanks people
 
Last edited:
ok so now i have out put of 100v is this the rms value because i cant get the sin wave on the simulation , would be great help
 
Last edited:
Hello,

Can you post a schematic in the form of a picture instead?
 
thanks i have now made it so it can be veiwed , kinda embarrasing Im now getting no fs value for v1 v2 and v3 .
ive uploaded picture and working schematic thanks for your time
 

Attachments

  • scematic.png
    27.4 KB · Views: 455
  • GroupFinverter.sch
    11.2 KB · Views: 209
Hello again,

What simulator are you using? Do you need a ground for the lower transistors and the battery?
 
Sorry about that , now the output is 100V and the simulation result shows just flat 100v is this rms or DC and my design is wrong
 

Attachments

  • working.png
    17.8 KB · Views: 360
  • GroupFinverter.sch
    11.2 KB · Views: 176
Hi,

Your output should be switching if the drive is correct. Did you check the drive signals to see if they are correct?
What are those blocks with outputs labeled "GA2" etc.?
 
Status
Not open for further replies.

Similar threads

My inverter doesn't work.
2
Replies
24
Views
3K
Lightium
V
  • Question
3 Phase Intelligent Power Modules as H-Bridge Configuration
Replies
1
Views
1K
rjenkinsgb
V
  • Question
V/F Control Of Single Phase PSC Motors
Replies
7
Views
2K
rguttenb_newb
R
T
Could use checking of my schematic for Teensy Audio Shield pcb
Replies
17
Views
3K
TonyAme
T
A
  • Question
How to use single phase 220VAC inverter in split phase setup
Replies
3
Views
2K
azaxi
A
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…