hello.
Thank you as it makes a lot of sense now so an LC combo would be better.i really need to go read up a few things again.
anyway since we are experimenting with different topologies and this one uses a push-pull config to drive a centre tap transformer.
Our main concern now is protecting the mosfet power stage from transformer spikes and other hazards and you said something about a snubber but i read that the snubber circuit has to be carefully calculated.
anyway i was wondering if there are any other suggestions and recommendations i dont know about in fully protecting the switching mosfets power stage.
I know about TVS diodes but not much but checking it out.
any ideas would be fully appreciated.
Thank you as it makes a lot of sense now so an LC combo would be better.i really need to go read up a few things again.
anyway since we are experimenting with different topologies and this one uses a push-pull config to drive a centre tap transformer.
Our main concern now is protecting the mosfet power stage from transformer spikes and other hazards and you said something about a snubber but i read that the snubber circuit has to be carefully calculated.
anyway i was wondering if there are any other suggestions and recommendations i dont know about in fully protecting the switching mosfets power stage.
I know about TVS diodes but not much but checking it out.
any ideas would be fully appreciated.