MrDEB
Well-Known Member
this is supposed to de bounce the optical intrrupter switch but values for resistors and capacitors were not listed in schematic.
just took a stab at it.
simed in LT spice but creating switch bounce??
inputed a pwl with lots of different voltages (2-5v) with different rise times)
output is nice and square but right??
going to use for a wind direction sensor connected to an 18F452 PIC.
basically an up/down counter.
using two interrupter switches on one slotted wheel.
just took a stab at it.
simed in LT spice but creating switch bounce??
inputed a pwl with lots of different voltages (2-5v) with different rise times)
output is nice and square but right??
going to use for a wind direction sensor connected to an 18F452 PIC.
basically an up/down counter.
using two interrupter switches on one slotted wheel.