Hi all,
I'm working on a project that needs to isolate/evaluate individual thermocouple signals and send a go/no go result to a LED. I'd like to use just one TC amplifier circuit in this tester, so I plan to use 4051 multiplexers to index the specific TC signals to be sent to the amplifier circuit.
The 4051 needs a 3-digit logic input to go to a specific output pin and the BS2 should be able to handle this with 3 outputs that would be at either 0 or 1 (1,0,0; 1,0,1 etc) going to the logic inputs on the 4051's. I'm new to PBasic and BS2's but have many years of VBA programming experience, so learning how to code the BS2 shouldn't be too difficult. What I'm wondering is if the BS2 can be programmed to output the needed logic signals when it gets a high input from a 4017 counter, or from a 555 oscillator (the clock for the 4017). All advice is appreciated!
Gary
I'm working on a project that needs to isolate/evaluate individual thermocouple signals and send a go/no go result to a LED. I'd like to use just one TC amplifier circuit in this tester, so I plan to use 4051 multiplexers to index the specific TC signals to be sent to the amplifier circuit.
The 4051 needs a 3-digit logic input to go to a specific output pin and the BS2 should be able to handle this with 3 outputs that would be at either 0 or 1 (1,0,0; 1,0,1 etc) going to the logic inputs on the 4051's. I'm new to PBasic and BS2's but have many years of VBA programming experience, so learning how to code the BS2 shouldn't be too difficult. What I'm wondering is if the BS2 can be programmed to output the needed logic signals when it gets a high input from a 4017 counter, or from a 555 oscillator (the clock for the 4017). All advice is appreciated!
Gary