booboojerkers
New Member
Hi,
I have come across an old Tektronix 2230. It powers up and does have a display but with only a single dot. With the little that I know about troubleshooting scopes, this may indicate something wrong with the horizontal section (sweep generator locked up?).
Any suggestions on how to approach this fix? The beam is not moving on the time x axis as a scope typically does when you fire it up.
If this scope is going to cost me an arm and a leg to fix this type of issue, It may just be more worth it to spend a few hundred $ to get something that's already in working condition.
Any feedback is greatly appreciated.
Thanks,
Robert
I have come across an old Tektronix 2230. It powers up and does have a display but with only a single dot. With the little that I know about troubleshooting scopes, this may indicate something wrong with the horizontal section (sweep generator locked up?).
Any suggestions on how to approach this fix? The beam is not moving on the time x axis as a scope typically does when you fire it up.
If this scope is going to cost me an arm and a leg to fix this type of issue, It may just be more worth it to spend a few hundred $ to get something that's already in working condition.
Any feedback is greatly appreciated.
Thanks,
Robert