Marks256
New Member
I just about got my eeprom programmer done(pics later). I want to solder it together, but veroboard is freakishly time consuming...
How would i make my own PCB? I am going to order from jameco again soon, and i think they sell kits.
What do i need for tools? I have read a few on here(electro-tech) before, but never really payed attention. I think i remember reading something about printing the board off, and then ironing it on, or something like that?
The programmer consists of 3 flip/flops, a few caps, i think i will add a few transistors for stability, and possibly a ZIF socket and a DB25 connector, so i dont think this is TOO difficult.
Thanks!
How would i make my own PCB? I am going to order from jameco again soon, and i think they sell kits.
What do i need for tools? I have read a few on here(electro-tech) before, but never really payed attention. I think i remember reading something about printing the board off, and then ironing it on, or something like that?
The programmer consists of 3 flip/flops, a few caps, i think i will add a few transistors for stability, and possibly a ZIF socket and a DB25 connector, so i dont think this is TOO difficult.
Thanks!