Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Boncuk said:Hi watzmann,
I redrew the circuit. That's about the way a clean schematic should look like. An unnecessary bend like the net from C Q12 to X7-1. Taking a close look at the component numbering I think it is pretty much like arabic writing - from right to left.
Schematics are normally read from left to right, which means the part numbers should start at a low number at the left side.
Also, missing numbers, e.g. Q1 and Q6 through Q8 may be confusing, since the reader will look for the numbers. Start from 1 and let Eagle automatically assign numbers.
From the logic the circuit will pull the outputs low when a base voltage is applied.
Boncuk
Pommie said:Your circuit is identical except for changing it so it complies with current fashion! My assumption was that the OP wanted to know if it was functionally correct, with the information available I think Jim has the correct response. You're reply may just confuse the OP.Mike.