Hello,
I am designing a PCB which holds components such as a DC-DC high voltage converter (12VDC to [0-500VDC]) alongside a dual output DC converter which run off the same input supply.
The voltage outputs from all there are used to drive a sensitive equipment like an APD. I would like to design this PCB so that I can minimize any noise at the input and output of these converters. I added that components that the high votlage converter manufacturer has suggested using their evaluation board, but they also suggest to add extra filtering to improve performance.
Any suggestions?
thanks
I am designing a PCB which holds components such as a DC-DC high voltage converter (12VDC to [0-500VDC]) alongside a dual output DC converter which run off the same input supply.
The voltage outputs from all there are used to drive a sensitive equipment like an APD. I would like to design this PCB so that I can minimize any noise at the input and output of these converters. I added that components that the high votlage converter manufacturer has suggested using their evaluation board, but they also suggest to add extra filtering to improve performance.
Any suggestions?
thanks