Hi I really need advice/help!!
I have a OEM satnav screen im trying to use in a car pc setup. The monitor opens and shuts automatically on recieving a power signal and also on a button push.
The motor is DC with a gear on the shaft going to a pot.
It was working but the oem boards have been broken by myself (foil ribbon cable linking two pcbs has 4 tracks torn) the potentiometer fell apart and I think a component like an inductor is damaged on the board....
so I am wondering if I can make my own system on some verro/copper board but havent a clue where to start...I did GCSE Electronics and A-Level but don't know any circuits which would help me :-(
I am in your hands people!
Karl
I have a OEM satnav screen im trying to use in a car pc setup. The monitor opens and shuts automatically on recieving a power signal and also on a button push.
The motor is DC with a gear on the shaft going to a pot.
It was working but the oem boards have been broken by myself (foil ribbon cable linking two pcbs has 4 tracks torn) the potentiometer fell apart and I think a component like an inductor is damaged on the board....
so I am wondering if I can make my own system on some verro/copper board but havent a clue where to start...I did GCSE Electronics and A-Level but don't know any circuits which would help me :-(
I am in your hands people!
Karl