vinodquilon
Member
Cadsoft Eagle 'drill size' 'clearance' error
How can I solve drill size DRC error in Cadsoft Eagle ?
In the Hole properties there is no options to adjust drill, only 0.02 is the one option.
Is manual routing or wire-width reduction are the only options to avoid 'clearance' error in PCB ?
How can I solve drill size DRC error in Cadsoft Eagle ?
In the Hole properties there is no options to adjust drill, only 0.02 is the one option.
Is manual routing or wire-width reduction are the only options to avoid 'clearance' error in PCB ?
Last edited: