discostuee
Member
I have purchased a amp unit and a sub driver and built a box, my only issue is i think i need a crossover as i need to remove all the high and middle tone and only leave the bass. this is for a DJ speaker with bass bin.
If someone can help with a schematic design for a variable one i would appreciate it.
the details for them both are.
Driver details:
Main Parameters:
Nominal diameter: 15”
Ohms: 8 ohms
Power handling Peak: 400 watts
Power Handling RMS: 200watts
Sensitivity: 96.4 db
Frequency Range: 48-4500hz
Thiele-Small Parameters
Fs 52.8Hz
Re 6.0 Ohms
Sd 34.6 sq.mm
Qms 9.9
Qes 0.60
Qts 0.57
Mms 28.8gr.
BL 9.8 Tm
Xmax +/- 5 mm
Le 0.6mH
Ref 101.6dB"
Amp modual:
Max Power: 400W
Sensitivity: 98dB
Frequency response: 45Hz-20Khz ( -3dB)
Microphone/Line input
Volume control
If someone can help with a schematic design for a variable one i would appreciate it.
the details for them both are.
Driver details:
Main Parameters:
Nominal diameter: 15”
Ohms: 8 ohms
Power handling Peak: 400 watts
Power Handling RMS: 200watts
Sensitivity: 96.4 db
Frequency Range: 48-4500hz
Thiele-Small Parameters
Fs 52.8Hz
Re 6.0 Ohms
Sd 34.6 sq.mm
Qms 9.9
Qes 0.60
Qts 0.57
Mms 28.8gr.
BL 9.8 Tm
Xmax +/- 5 mm
Le 0.6mH
Ref 101.6dB"
Amp modual:
Max Power: 400W
Sensitivity: 98dB
Frequency response: 45Hz-20Khz ( -3dB)
Microphone/Line input
Volume control