rapper_eater
New Member
Hi,
This problem is largely my fault but I was wondering what y'all think...is it fixable or did I destroy this fine machine of mine?
I burned off one of my circuit paths on my ASR-X (drum machine). This is causing the drum machine to skip sounds. For example it will jump from sound bank ten to sound bank Fifteen.
LINK DELETED - MODERATOR
PLEASE POSTS ANY PICTURE ON THIS SITE, NOT ELSEWHERE
I've supplied a picture to show where the path is burned (it's on the back side of the board).
I was trying to install new rotary nobs. But it look like I really screwed up.
Any suggestions other then learn how to solider.
The Drum Machine is an ASR-X pro by Ensoniq.
Thanks for your help!
This problem is largely my fault but I was wondering what y'all think...is it fixable or did I destroy this fine machine of mine?
I burned off one of my circuit paths on my ASR-X (drum machine). This is causing the drum machine to skip sounds. For example it will jump from sound bank ten to sound bank Fifteen.
LINK DELETED - MODERATOR
PLEASE POSTS ANY PICTURE ON THIS SITE, NOT ELSEWHERE
I've supplied a picture to show where the path is burned (it's on the back side of the board).
I was trying to install new rotary nobs. But it look like I really screwed up.
Any suggestions other then learn how to solider.
The Drum Machine is an ASR-X pro by Ensoniq.
Thanks for your help!
Last edited by a moderator: