A andrew2022 New Member Apr 8, 2004 #1 i have a usb hub but i have damaged the connector what goes from the cable (side where it goes 2 usb) to hub. i have VB, D-, D+, GND and +5v rote on the board. which way do i connect the wires ( red, black, green nd white) 2 the board? thanx
i have a usb hub but i have damaged the connector what goes from the cable (side where it goes 2 usb) to hub. i have VB, D-, D+, GND and +5v rote on the board. which way do i connect the wires ( red, black, green nd white) 2 the board? thanx
J jem Member Apr 10, 2004 #2 USB wire colors are standard. Here is the description: Red: +5V White: D- Green: D+ Black: Gnd. Hope that helps. Jem
USB wire colors are standard. Here is the description: Red: +5V White: D- Green: D+ Black: Gnd. Hope that helps. Jem
A andrew2022 New Member Apr 11, 2004 #3 yes, but whats the VB? (altho i think it was that pin wot was not connected)
J jem Member Apr 11, 2004 #4 I suggest not connecting it. Give it a try, and see if it works without.