Hi, this is probably very simple, but i still need some help. I have a 12V helmet camera, powered by an external 12V battery pack. Whenever i want to turn the power ON or OFF, i have to connect/disconnect the power cable.
I would like to add a small, illuminated rocker switch, so i can just leave everything hooked up and simply power it from the switch. I found a switch i liked at the local electronics surplus store, and it has 3 connector pins. The camera power cable has 2 wires, positive and negative. How should i interconnect everything? The 2 wires from the battery need to input to the switch, and then output 2 wires from the same switch to a 2.1mm DC jack.
Any help would be appreciated. thanks!
I would like to add a small, illuminated rocker switch, so i can just leave everything hooked up and simply power it from the switch. I found a switch i liked at the local electronics surplus store, and it has 3 connector pins. The camera power cable has 2 wires, positive and negative. How should i interconnect everything? The 2 wires from the battery need to input to the switch, and then output 2 wires from the same switch to a 2.1mm DC jack.
Any help would be appreciated. thanks!