porchechop
New Member
I understand that the circuit posted on the site www.555-timer-circuits.com of the servo controller (under servo tester) works as follows: u turn the potmeter and the servo turns by a degree proportional to degree the potmeter is turned.
Now i wantted to create an adjustment for this circuit.
first of all i want to create this with a joystick instead of a potmeter. But the joystick should also have to be pulled in reverse, meaning that i basicly want to control the amount the servo turns with a joystick, in both ways.
However, i am not sure if the initial circuit makes sure the servo turns back to the original state, but in what i have in mind it should do this.
Any help is appreciated
im kind of a noob in this :s
thx in advance
porchechop out
Now i wantted to create an adjustment for this circuit.
first of all i want to create this with a joystick instead of a potmeter. But the joystick should also have to be pulled in reverse, meaning that i basicly want to control the amount the servo turns with a joystick, in both ways.
However, i am not sure if the initial circuit makes sure the servo turns back to the original state, but in what i have in mind it should do this.
Any help is appreciated
im kind of a noob in this :s
thx in advance
porchechop out