i connected a manuall switch to clock circuit (S). because i want to manually control the ring. when s is pressed clk circuit generates a pulse which is input to 4013 . so L1 should be on and L2 off
at another press L1 off and L2 on.
for startig this circuit i connect Q1 to high and then disconnect it.
Not a very clear diagram. But here are some things I see wrong with it:
Q1~ and Q2~ should NOT be tied to Vss.
L1 and L2 (LEDs?) should have current limiting resistors. Try 1K.
Your clocking/Power switch circuit makes no sense. You need a steady 9V on Vdd. Then you also need to debounce the switch before feeding it into the clock input of the 4013.
oh sorry there was a mistake !!!!
i connected vdd to manuall switch.
i should connect permanently to vdd.
i think q~ should be grounded.
so,for the rest of the part the logic of circuit is wright.
oh sorry there was a mistake !!!!
i connected vdd to manuall switch.
i should connect permanently to vdd. i think q~ should be grounded.
so,for the rest of the part the logic of circuit is wright.
hi neptune,
My concern is that if you have been running the 4013 wired in that configuration, the 4013 may have died, so you may not get the operation you are expecting.