Hi there
I would like to use the reset circuit you see in the attachment in a system that can reset the whole system by disconnecting the +12V from the InputVoltage for two seconds and then connecting the +12V to the InputVoltage again. InputVoltage supplies the system and +12V supplies only the reset circuit. The reset signal (when it is high) comes from the system itself.
I have this design but for some reason it woks for some boards and not to all boards, Do you think it is a problem in the design?
Regards,
Omar
I would like to use the reset circuit you see in the attachment in a system that can reset the whole system by disconnecting the +12V from the InputVoltage for two seconds and then connecting the +12V to the InputVoltage again. InputVoltage supplies the system and +12V supplies only the reset circuit. The reset signal (when it is high) comes from the system itself.
I have this design but for some reason it woks for some boards and not to all boards, Do you think it is a problem in the design?
Regards,
Omar