• Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

Repairing QPAD QH-90 Headset

Not open for further replies.


New Member
Hi, so I have a QPAD QH-90 gaming headset that I am trying to repair. From the headset is a cable that then splits into a TRS plug for audio, and one for the microphone. The cable for the microphone broke behind the plug, so I was going to solder on a new plug. But the wires inside doesn't look like they usually do. There are two different colors of copper wire that were twisted around each other. One is red, and one is copper colored, and there's some fuzz too.

My question is which goes where on a TRS plug? Pictures attached


Tony Stewart

Well-Known Member
Most Helpful Member
Jack has 2 solder tabs which are the centre wires (2=Left+right). The braided shield goes to the 3rd solder point (common gnd) which also has the crimps that hold the cable tight.
Not open for further replies.

Latest threads

EE World Online Articles