Removing microprocessor

Status
Not open for further replies.

laispais

New Member
How do I remove this processor? (Y1)
 

Attachments

  • 20230507_203120.jpg
    1.6 MB · Views: 147
  • 20230507_203228.jpg
    1.7 MB · Views: 138
Y1 is a crystal.

If you mean what's under the black blobs (pictures are obviously not the same circuit board), you don't. It's a "chip on board" – a piece of silicon connected by tiny bond wires to the board. It's an IC minus the package.
 
I think the best approach to desolder an SMD microcontroller is to use a desoldering station. Weller is good. Here are some other recommendations too:


Here are also some info about desoldering guns and other necessary components for electronics.

 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…