micheadache
New Member
__CONFIG(WDTDIS & XT);
basically changes my config bits to using XT of oscillator and /MCLR is external...however, i have a switch (RE3) attached at my board. RE3 happens to share the same pin as /MCLR and therefore i set the config bits to "RE3 is digital input" instead.
i get an output of "f" most of the time over at TeraTerm, i am not sure as to why nothing comes out at HyperTerminal.
hope to get ur guidance
basically changes my config bits to using XT of oscillator and /MCLR is external...however, i have a switch (RE3) attached at my board. RE3 happens to share the same pin as /MCLR and therefore i set the config bits to "RE3 is digital input" instead.
i get an output of "f" most of the time over at TeraTerm, i am not sure as to why nothing comes out at HyperTerminal.
hope to get ur guidance