PIC16F690 Sine Wave

Status
Not open for further replies.

JasonMcG

Member
How do you go about coding in assembly to code a sine wave? I was thinking of using a lookup table but not sure what I should do
 
Here is a DDS generator for AVR:**broken link removed**
and assembly code **broken link removed**
Should be easy to convert for PIC
 
PortC can be used I was thinking It was just 7 bit wide but its 8
 
Last edited:
I simply outputted a square wave to a resistor/capacitor network and it was recognised by the telephone DTMF so it was quite accurate.
 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…