Have you even bothered to just read the datasheet of your PGA device? Because although the same pin numbering is often used for packages, it is not always necessarily the same. And how do you know where to bond if you don't even know what the pins do in the first place? (again, the datasheet).
If you, for some reason, know where the wires go without knowing what the part is and are only after standard pin numbering you might try googling around until you find a PGA part and look at it's datasheet and copy the pin numbering from there (though PGA parts do seem to be hard to find).
I wish there were more PGA parts especially for big chips- I just found out you can wire wrap them! No expensive 8-layer boards!