edofbrighton
Member
Hello,
I have an op-am circuit which doesn't work. The circuit is a simple differential op-amp circuit, which is supposed to get the diffence in the two outputs from a wheatstone bridge.
Instead the output is just the postive power supply voltage. Does anyone know why this might be happening? I've used the circuit before to do exactly the same thing and it worked. The pins all appear to be connected properly, so I really have no idea why it's not working. I thought i might be because it is now on PCB, but i tried it on bread and it didn't work on that either.
pin 2-ve
pin3 +ve
pin4 ground
pin 7 power supply
pin6 out
it is a rail-to-rail op-amp and there is no feedback.
data sheet: https://www.electro-tech-online.com/custompdfs/2011/02/0900766b8078002b.pdf
thanks ed
I have an op-am circuit which doesn't work. The circuit is a simple differential op-amp circuit, which is supposed to get the diffence in the two outputs from a wheatstone bridge.
Instead the output is just the postive power supply voltage. Does anyone know why this might be happening? I've used the circuit before to do exactly the same thing and it worked. The pins all appear to be connected properly, so I really have no idea why it's not working. I thought i might be because it is now on PCB, but i tried it on bread and it didn't work on that either.
pin 2-ve
pin3 +ve
pin4 ground
pin 7 power supply
pin6 out
it is a rail-to-rail op-amp and there is no feedback.
data sheet: https://www.electro-tech-online.com/custompdfs/2011/02/0900766b8078002b.pdf
thanks ed