I have long been an electronics freak, however I have always strayed away from the programming aspect. So I know very little about all of this.
I wanted to create a simple program on an EEPROM chip (24c08). From what I have gathered, I have to purchase a programming machine....., right? I would have thought that there was a way to program the chip with simple software, through the serial port.... or something of that nature. Please help.
I am making a cable tester (cat 5e). And instead of having some LEDs lighting up in a sequence, I wanted to have an LCD to say straight-thru, x-over, roll-over, bad, etc.... I'm not sure if any of this makes sense without seeing the schematic so here is the webpage
I admire your passion for experimentation and building, but why re-invent the wheel ?
To drive an lcd to display the info you require is not a light hearted task
I'd suggest going with the circuit you already have