Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

New little project.

Status
Not open for further replies.

Nigel Goodwin

Super Moderator
Most Helpful Member
Just had some more PCB's arrive, and 3D printed some mounting clips for them :D

Boards_Sml.jpg
Clips_Sml.jpg
Board&Clips_Sml.jpg
In_Pipe_Sml.jpg
 
OK, gonna have to ask, what's it doing in the waste pipe? Is this going to be like horrible histories? I hope so.

Mike.
 
That could be interesting, but the board edges mite swell if they soak up too much solvent.

Sorry, I was referring to gluing the 3D printed mountings in the pipe, not the PCB in the slots - that's nice and tight anyway - but assuming anything is needed, I'd use hot melt glue on the slots.
 
Status
Not open for further replies.

Latest threads

New Articles From Microcontroller Tips

Back
Top