Need help identifying a component

B

bigshaff44

New Member
I need help identififying a bad component out of a dehydrater. It looks like it might be a diode or a small fuse? It was inline on onr leg of the power. It is white and round with the following markings on it:
186 T ( the T is inside of a triangle)
UMI
2A 250V
169 Degrees C E1
I would really appreciate any help with this and if you could tell me were I could I buy a replacement that would be even better. Thanks
 

Attachments

  • IMG00023-20100912-1907[1].jpg
    402.5 KB · Views: 537
Sounds like it might be a 163^C thermal fuse
 
I'd say a 169^C thermal fuse. If it is open circuit, it is blown - if it is short circuit, it is good. It is best to crimp to it rather than soldering - you can burn them out with a soldering iron.

Where abouts in the world are you? To help you find one, we need to know where you are.

Andrew
 

As long as that is 169 degrees Celsius this will work.
This particular site lists it as 171 which is not quite correct.
That's the the upper tolerance in which it would trip.

**broken link removed**
 
You must log in or register to reply here.

Similar threads

C
  • Question Question
Help identifying component
2
Replies
21
Views
5K
Les Jones
L
J
  • Question Question
Help! Identifying and locating a retailer.
Replies
2
Views
2K
Jinxeruk
J
S
  • Question Question
Need help in repairing a dead motherboard
Replies
3
Views
1K
ahsrabrifat
A
D
  • Question Question
Help with identifying a transistor
Replies
3
Views
4K
aliarifat794
A
F
  • Question Question
Need help identifying component in charging circuit, marked "SKLJJ"
Replies
6
Views
4K
Fedde
F
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…