Hey, this may sound like a silly question. But can I use a N-Channel FET to switch a positive load?
IE.
Gate - (low trigger) negative
Drain - Load
Source - +12VDC
Just curious if this is an OK thing to do? I'm guessing not. will only work as a P Channel FET?
The FET in question https://www.farnell.com/datasheets/65413.pdf
Cheers
IE.
Gate - (low trigger) negative
Drain - Load
Source - +12VDC
Just curious if this is an OK thing to do? I'm guessing not. will only work as a P Channel FET?
The FET in question https://www.farnell.com/datasheets/65413.pdf
Cheers
Last edited: