bananasiong
New Member
so if i increase the inductance 10 times (100mH), and reduce the capacitance for 10 times (0.0022uF), will i get better sensitivity?The inductor in the receiver's circuit is the most sensitive part for the signal.
i will try both and see the result.I don't remember if it is the most sensitive when it is vertical or horizontal when compared to the transmitter's loop that is flat on the floor.
actually the rx frequency is around 10730Hz, i assume it as 10kHz. so i will change the tx frequency to 9600Hz by changing the value of the resistor and see the result. thanks for helping me a lotYou need to change the frequency of the transmitter and monitor the receiver for its highest sensitivity to a frequency. It might peak at 9600Hz but not be very sensitive at 10kHz.