Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

lcd ammeter

Status
Not open for further replies.

windozeuser

Member
Hi everyone,

I was wondering what would be the simplest way to make a digital ammeter (Displays ampage on a lcd)


From 200 Ma to 2 Amp's

If anyone could give me a site or draw a schematic It would be of much help

Thanks :D
 
The absolute easiest way is to purchase a prebuilt LCD Ammeter module. You could also use a shunt across one wire to the load, measure the voltage drop and compute the current draw.
 
are the lcd ammeter modules panel mount, i kinda want to use it to monitor the current output of a powert supply im building
 
Simplest way (to me) would be to pass your current trough a small resistor in series with whatever load. This will cause a small voltage drop over the resistor wich is relative to the current (more current, bigger voltage drop). Then feed this voltage into a A/D converter with direct lcd-drive and you're done.

If you're talking 'bout a HD44780 LCD then i think there's no other way then using a pic or some other form of control
 
windozeuser said:
are the lcd ammeter modules panel mount, i kinda want to use it to monitor the current output of a powert supply im building

You can get all kinds of LCD meters, many either come with (or have the option of) panel mounting. Most are usually based on something like the 7107 digital meter chip, you may need to use an external current shunt to use one as an ammeter - but again, these are usually available as an option with the modules.
 
Exo said:
... pass your current trough a small resistor in series with whatever load. This will cause a small voltage drop over the resistor wich is relative to the current (more current, bigger voltage drop). Then feed this voltage into a A/D converter with direct lcd-drive and you're done.

With this approach, you have to be careful if you intend to use the same circuit you are monitoring to also power the measurement circuit (and the supply you are monitoring is >5V). The easy way to do it is to put the power resistor in series with the ground path (so that the ADC has the same ground reference). The problem is that you have unwanted impedance in the return path. If you put the resistor on the high side, you need to supply a conditioning circuit to ground reference and limit your voltage before you input it to the ADC.

If you are using an independent supply .... no problems.
 
Thanks for your replies i think im gonna buy a ammeter modulue and mount it in the case of my power supply so i can set the output current easily
 
windozeuser said:
... im gonna buy a ammeter modulue and mount it in the case of my power supply so i can set the output current easily

Perhaps we are confused, I dont believe the modules or circuits mentioned allow you to SET the current, the only allow you to READ the current.
 
No Reading it is all i need im gonna connect a pot on the output and read the voltage and current output it is at
 
If you really want a good controllable power supply you should look for circuitry containing a voltage-regulator and a current-limiter. They will allow you to control voltage and current independent of each other.
So you can set a certain voltage & current and choose wich one of the 2 is in charge.

Adding a pot on the output will change voltage & current at the same time. Making it difficult to set a value. Also too much will depend on the load
 
Status
Not open for further replies.

New Articles From Microcontroller Tips

Back
Top