I am a beginner and am having trouble putting together a ICD2 clone from schematics, board design, photo and a part list. The source of my confusion is two parts that are said to be the same in the parts list, but appear nothing alike in the board design and a photo.
L1, L2 = 100μH
They are the parts, it took me ages to figure out what a L* is, but i figured they are inductors right?
Anyway, in the photo below L2 looks like the inductors i can find online, where as L1 just looks like a wire? What am i reading wrong? Do i just put a wire into L1, but they are both the same μH??
Thank You,
Mitch
**broken link removed**
L1, L2 = 100μH
They are the parts, it took me ages to figure out what a L* is, but i figured they are inductors right?
Anyway, in the photo below L2 looks like the inductors i can find online, where as L1 just looks like a wire? What am i reading wrong? Do i just put a wire into L1, but they are both the same μH??
Thank You,
Mitch
**broken link removed**