Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

identifying the flyback pinout

Status
Not open for further replies.
the only idea I have is to ground all the pins. but I could also buy a less powerful ballast, like the 40w ballast that the guy in the video used. but this is more expensive than buying about 5 meters of wire and then dividing it into pieces to ground each pin. I think that sticking these wires to the floor with tape is enough. oh well, i will see if i can find a way to isolate these pins by searching somewhere, probably in this forum there is a thread talking about isolating the pins from a flyback
 
Status
Not open for further replies.

Latest threads

New Articles From Microcontroller Tips

Back
Top