I have it.
Build two timers like in post #1.
The first timer: remove D1, D2, Relay....
Connect a 1k to 10k resistor from Q14 to RESET pins. (set to run for 24 hours)
This will cause the timer to run all the time and never stop.
Q14 will be low for 24 hours and go high for a short time set by the new resistor and C-RESET.
The reset button is OK, just to start the timer at time 0.
The second timer is not modified. Set to run for 2 hours.
Connect Q14 of first board to RESET on second board. (timer 1 pushes reset on timer 2)