natural_orange
New Member
I want to build a connector to connect my explorist 200 to my computer via serial port.
Source: **broken link removed**
There schematic (**broken link removed**) is kinda vague as to where the capicitors go and what resistor to use.
Also where is a good place to buy the components?
- Cable with 9-pin connector for serial port (Female) -HAVE
- Cable with USB connector. - HAVE
- One chip MAX-232,
- Dip-socket for this chip with 16 pin
- One resistor 1 to 5 Ohm
- Five capacitors 0.33 - 1 mikroFarad,
What kind of board should I mount it to? like a breadboard or something?
Source: **broken link removed**
There schematic (**broken link removed**) is kinda vague as to where the capicitors go and what resistor to use.
Also where is a good place to buy the components?
- Cable with 9-pin connector for serial port (Female) -HAVE
- Cable with USB connector. - HAVE
- One chip MAX-232,
- Dip-socket for this chip with 16 pin
- One resistor 1 to 5 Ohm
- Five capacitors 0.33 - 1 mikroFarad,
What kind of board should I mount it to? like a breadboard or something?