allcanadian
New Member
To the many skeptics here----here is a good example of "doing it the right way" with replications to prove this fact.
EXPLANATION VIDEOS
YouTube - ThaneCHeins's Channel
Perepiteia Generator Operation Explanation – Draft 1 – June 20th, 2008
High Voltage Coil Effects
Thane C. Heins
Introduction
The Perepiteia Generator employs high voltage coils to counteract the effects associated with Lenz’s Law and the Law of Conservation of Energy. Whereas a conventional generator high current coil design causes the prime mover to decelerate under load – the Perepiteia high voltage coil design causes the prime mover to accelerate. If high current and high voltage coils are employed simultaneously, the acceleration provided by the high voltage coils can completely eliminate Lenz’s Law (deceleration) effects and even provide additional acceleration despite high current coil loading.
This paper is intended to explain (only) one aspect of how this acceleration may be occurring with respect to how high voltage wire eddy currents affect the coils ability to produce an induced magnetic field as dictated by Lenz’s Law. There of course are other possible reasons for the observed acceleration (including core loss reduction) which will be dealt with in greater detail at another time.
Basic Observations, Critical Minimum Rotor Speed/Frequency
Conventional generators employ low gauge – high current (HC) wire to reduce losses associated with resistance and eddy currents. Figure 1 shows how current is distributed through a typical HC coil. The current flows evenly throughout the entire conductor and the induced magnetic field emanates out in a radially symmetrical pattern.
The high voltage coil (HV) in Figure 2 on the other hand shows what happens in the HV coil as the rotor speed exceeds the critical minimum velocity.
Rotor Speed Critical Minimum Velocity
Above a certain rotor speed or frequency the HV coils cause system acceleration in violation of Lenz’s Law.
Below this rotor RPM or frequency the HV coils act in accordance with Lenz’s Law and cause the system to decelerate under load.
The question is why?
What occurs as frequency rises to change the coils’ performance?
HOW GENERATOR HIGH VOLTAGE COILS CAUSE ACCELERATION
At the critical threshold speed or frequency (dictated by the coils inductance) the HIGH VOLTAGE COIL ceases to act as an INDUCTOR (storing energy in the electromagnetic field and producing a Lenz's Law repelling action to the approaching magnetic field) and begins to act as a CAPACITOR (storing energy in the electrostatic field between the wires).
This is clearly shown in the video FREQUENCY VARIATIONS & MULTI LAYER HV COIL ACCELERATION: YouTube - FREQUENCY VARIATIONS & MULTI LAYER HV COIL ACCELERATION
When a North Pole magnet approaches a HIGH VOLTAGE COIL above the critical threshold speed/frequency a North Pole repelling magnetic field as per Lenz's Law is not produced because the coil's impedance has impeded the current flow within the coil sufficiently. Voltage is built up in the coil and stored in the electrostatic field between the wires like a capacitor.
When the North Pole magnet is TDC - Top Dead Centre - neither approaching nor receding away from the coil - the coil's stored voltage, which is now at a maximum, is released through the coil's DC resistance and a magnetic field is produced according to Lenz's Law (at this split second at TDC the AC sine wave is changing direction and as far as the coil is concerned frequency is briefly 'zero' and coil impedance is zero so current is allowed to flow - thus producing a delayed North Pole magnetic field which now pushes away on the receding magnet and simultaneously attracts the approaching opposite South pole on the rotor
Thane
--Latest replication video-- **broken link removed**
A generator which accelerates under load, LOL, how original. The generator shown above is a good example of the new technologies which will utilize the electric force to improve efficiency. Quite simply--- Lenz's law has no application when energy is generated and stored as capacitance, an electric field. In the near future Mr.Heinz is going to realize that the HV coil can be precharged to any level by utilization of high voltage/high frequency impulses. He will also understand that there is no such thing as overunity, you cannot violate the conservation of energy. The supposed "extra" energy utilized was always present but we have never set the proper electrical conditions to utilize it.
Regards
AC
EXPLANATION VIDEOS
YouTube - ThaneCHeins's Channel
Perepiteia Generator Operation Explanation – Draft 1 – June 20th, 2008
High Voltage Coil Effects
Thane C. Heins
Introduction
The Perepiteia Generator employs high voltage coils to counteract the effects associated with Lenz’s Law and the Law of Conservation of Energy. Whereas a conventional generator high current coil design causes the prime mover to decelerate under load – the Perepiteia high voltage coil design causes the prime mover to accelerate. If high current and high voltage coils are employed simultaneously, the acceleration provided by the high voltage coils can completely eliminate Lenz’s Law (deceleration) effects and even provide additional acceleration despite high current coil loading.
This paper is intended to explain (only) one aspect of how this acceleration may be occurring with respect to how high voltage wire eddy currents affect the coils ability to produce an induced magnetic field as dictated by Lenz’s Law. There of course are other possible reasons for the observed acceleration (including core loss reduction) which will be dealt with in greater detail at another time.
Basic Observations, Critical Minimum Rotor Speed/Frequency
Conventional generators employ low gauge – high current (HC) wire to reduce losses associated with resistance and eddy currents. Figure 1 shows how current is distributed through a typical HC coil. The current flows evenly throughout the entire conductor and the induced magnetic field emanates out in a radially symmetrical pattern.
The high voltage coil (HV) in Figure 2 on the other hand shows what happens in the HV coil as the rotor speed exceeds the critical minimum velocity.
Rotor Speed Critical Minimum Velocity
Above a certain rotor speed or frequency the HV coils cause system acceleration in violation of Lenz’s Law.
Below this rotor RPM or frequency the HV coils act in accordance with Lenz’s Law and cause the system to decelerate under load.
The question is why?
What occurs as frequency rises to change the coils’ performance?
HOW GENERATOR HIGH VOLTAGE COILS CAUSE ACCELERATION
At the critical threshold speed or frequency (dictated by the coils inductance) the HIGH VOLTAGE COIL ceases to act as an INDUCTOR (storing energy in the electromagnetic field and producing a Lenz's Law repelling action to the approaching magnetic field) and begins to act as a CAPACITOR (storing energy in the electrostatic field between the wires).
This is clearly shown in the video FREQUENCY VARIATIONS & MULTI LAYER HV COIL ACCELERATION: YouTube - FREQUENCY VARIATIONS & MULTI LAYER HV COIL ACCELERATION
When a North Pole magnet approaches a HIGH VOLTAGE COIL above the critical threshold speed/frequency a North Pole repelling magnetic field as per Lenz's Law is not produced because the coil's impedance has impeded the current flow within the coil sufficiently. Voltage is built up in the coil and stored in the electrostatic field between the wires like a capacitor.
When the North Pole magnet is TDC - Top Dead Centre - neither approaching nor receding away from the coil - the coil's stored voltage, which is now at a maximum, is released through the coil's DC resistance and a magnetic field is produced according to Lenz's Law (at this split second at TDC the AC sine wave is changing direction and as far as the coil is concerned frequency is briefly 'zero' and coil impedance is zero so current is allowed to flow - thus producing a delayed North Pole magnetic field which now pushes away on the receding magnet and simultaneously attracts the approaching opposite South pole on the rotor
Thane
--Latest replication video-- **broken link removed**
A generator which accelerates under load, LOL, how original. The generator shown above is a good example of the new technologies which will utilize the electric force to improve efficiency. Quite simply--- Lenz's law has no application when energy is generated and stored as capacitance, an electric field. In the near future Mr.Heinz is going to realize that the HV coil can be precharged to any level by utilization of high voltage/high frequency impulses. He will also understand that there is no such thing as overunity, you cannot violate the conservation of energy. The supposed "extra" energy utilized was always present but we have never set the proper electrical conditions to utilize it.
Regards
AC
Last edited: