Dear Sir,
I am a young electronics engineer, I am trying to control an Analog device ECG evaluation board( ADAS1000/ADAS1000-1) by Arduino uno. Is it possible to use Arduino Uno instead of EVAL-SDP-CB1Z?
What factors do you think should be consider for interface ADAS1000/ADAS1000-1 instead of EVAL-SDP-CB1Z?
I am talking about Bit numbers, frequency, ADC/DAC facilities,registers, SDRAM memory,internal RAM memory, data transfer rate etc.
Kindly consider the Arduino Uno main MCU datasheet and schematic diagram in attachment.
Hope you will response soon.