EasyEDA newbie question

Status
Not open for further replies.

bulaboo

New Member
Hello everybody!
I just downloaded EasyEDA standalone version and doing just fine, very beginning of the learning curve...

QUESTION: any idea how to do a resistor that is function of time?
For example, a resistor that goes from 5 Ω to 20 Ω in couple of seconds.
I try to simulate a DC motor and instead of a DC motor I have a resistor. I want to study how the rest of the circuit works on different loads.

All ideas are welcome! Thanks in advance!
 
Sort by date Sort by votes
Yeah, thanks. Good idea.

But that's no difference to manipulating a resistor —I have to run simulation after each change.
I was just thinking that there would be an easier way to connect an oscilloscope and get a plot of the changes, with one run.
 
Upvote 0 Downvote
Does Easy EDA do multi step or Monte Carlo on a parameter or device ?

You could do a stepped constant R that way.

Something like this (here I stepped V source) :




Regards, Dana.
 
Upvote 0 Downvote
danadak said:
Does Easy EDA do multi step or Monte Carlo on a parameter or device ?
You could do a stepped constant R that way.
Something like this …
Click to expand...
Thank you for the tip. I do not know, I have to study that.

To be honest, I am really, really novice with all this. It's a miracle that I learned this quickly to do some basic stuff. I have to catch up a few decades
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

P
EasyEDA Pro change layer while routing manually.
Replies
7
Views
4K
schmitt trigger
S
P
  • Question
Newbie question - basic simulation with amplifier AD620 which necessitate hours to be performed
Replies
19
Views
7K
Roff
P
  • Question
Has EasyEDA Pro killed the software?
Replies
16
Views
6K
For The Popcorn
F
printing a board using EASYEDA
Replies
13
Views
4K
MrDEB
B
EasyEDA standalone doesn't start
Replies
4
Views
2K
Visitor
V
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…