hi all
excuse me if this has been covered already
I have created board from schematic, and ran cam job
for gerber extended,...one prob tho...
using Viewplot,...i've noticed that the
part names are not showing on comp side (*.plc)
which I guess is the silkscreen top layer
what,..if anything do I need to do to make
sure that part names will show up on finished PCB?
thanks in advance
excuse me if this has been covered already
I have created board from schematic, and ran cam job
for gerber extended,...one prob tho...
using Viewplot,...i've noticed that the
part names are not showing on comp side (*.plc)
which I guess is the silkscreen top layer
what,..if anything do I need to do to make
sure that part names will show up on finished PCB?
thanks in advance