N NATY New Member Aug 17, 2010 #1 hi all excuse me if this has been covered already I have created board from schematic, and ran cam job for gerber extended,...one prob tho... using Viewplot,...i've noticed that the part names are not showing on comp side (*.plc) which I guess is the silkscreen top layer what,..if anything do I need to do to make sure that part names will show up on finished PCB? thanks in advance
hi all excuse me if this has been covered already I have created board from schematic, and ran cam job for gerber extended,...one prob tho... using Viewplot,...i've noticed that the part names are not showing on comp side (*.plc) which I guess is the silkscreen top layer what,..if anything do I need to do to make sure that part names will show up on finished PCB? thanks in advance
N NATY New Member Aug 18, 2010 #2 Solution first you add.... ok,...after having flipped this prob in my head I found it....for those who may have similar at some point, I provide the following: turn off all layers except the tNames group all of that layer, change Layer to tPlace Taa Daaaaa! now in your gerb view,..all part names will show on top silkscreen layer
Solution first you add.... ok,...after having flipped this prob in my head I found it....for those who may have similar at some point, I provide the following: turn off all layers except the tNames group all of that layer, change Layer to tPlace Taa Daaaaa! now in your gerb view,..all part names will show on top silkscreen layer