If you use R0201 resistors and JLC for assembly then you can't use the cheap service and have to use the dearer one.
In my case 5 boards went from $95 to $125 because of 1 resistor.
Nicely, it does warn you after you've submitted everything.
IntroductionVarious electrical components are used to achieve various roles in a printed circuit board. Therefore, a good PCB designer should have a complete understanding of such components and what ...
IntroductionVarious electrical components are used to achieve various roles in a printed circuit board. Therefore, a good PCB designer should have a complete understanding of such components and what ...
PCBWay is more expensive for basic service - I think it was quoted at $88 for assembly up to 25 boards and some limited number of components but they start adding fees for small parts, heavy parts, ets. Their boards are cleaner than jlc - especially castellated holes.
Yes, sir. They have PCB assembly services including through-hole assembly, SMT assembly, mixed assembly etc. But I am not sure about the price. Maybe Mr./Ms ZipZapOuch is right.