Hi
As a relative newbie and a total novice I'd like to add my two pennyworth .. .. in point form to achieve brevity
1. There are so many different bits of software relating to schematics/simulation and the like .. it is difficult to assess and decide which one to use because they all do something but none of them do everything and from a limited experience point of view it's almost impossible to make an informed choice. If you then ask in the forum, understandably, there are 47 differing opinions of which is best and you end up none the wiser.
2. The document was introduced to the forum yesterday by a much respected member, especially by me, to the extent that I immediately cut & pasted the document into my ring binder entitled 'Essential Information to Learn' .. ... but then the forum, including the guy who posted it have systematically anihilated the content as being flawed, in various degrees - just what is an novice suppose to think ?
I do think sometimes we are guilty of polishing the brass so much that the glare gets in the way
Respectfully
S