Hi,
newbie question please . . . . . .
I have the following circuit which will be part of a diagnostics card for a hobby system that I am buildiing. It is intended to turn on some LEDs based on the status of the inputs to the LS240. I would like to have the option to easily disable all of the LEDs, i.e., turn them off. If I set /1G & /2G HIGH, I think that the outputs will go tri-state?
Will the tri-state outputs be enough to keep the LEDs off? - I don't have enough space on the prototype board to include additional pull-ups.
(The enable inputs are currently shown open, but are actually tied to 0V in the design at the moment)
regards
Dave